Neck Φ5.1/Bottom Φ3.7

1.Locating: Use guide drill with 1500 rpm

•  Pierce cortex to locate. Ideal rotate speed: 1500rpm

2.Orientating: Use Φ2.0 Twist Drill with 1000rpm

•  Drill to 5mm, feel bone quality, use parallel pin to verify the direction. Sidecut drill can be used for changing direction.

•  Drill until stop ring.

•  Use depth gauge to detect hole's depth and bottom condition.

3.Reaming: Use Φ3.0 Twist Drill,Taper Drill, Taper Cortical Drill with 1000rpm

•  Normal Bone (D2-D3): Use taper drill of equal diameter and length as the implant's.

•  Soft bone (D4): Use smaller diameter taper drill.

•  Hard Bone (D1)： Use taper cortical drill specifically designed.

4.Implanting: turn clockwise up to a maximum of 25rpm

•  Implant by hand when there's 1 to 2 thread left.

•  Implanting depth should be the same as bone plane or under bone for 0.5-1mm.

•  Torque should be controlled between 25~40Ncm.